When are worm gear motors suitable for your products?
Worm gear motor is also called right angle gear motor. It‘s typically featured as below :
1, change transmission direction relying on its 90° output shaft.
2, High gear ratio ( range from 49:1 to 2450:1)
3, High Torque and Low Speed.
4, Quiet noise.
5, High holding torque (self-lock).
You could count on worm geared motors if your products have requirements in these aspects mentioned above.
Brushed Worm gear motors or brushless worm gear motors are suitable for intermittent work, like work scenarios in a smart lock, or electric blinds, where they motors are on for a few seconds or minutes each duty cycle.
The following are the worm gear motors we currently produce in our production line.
| Model(gearbox size) | Rate Voltage | Speed | max rated torque | max output shafts | Typical applications |
| HT-WOG34A(34x25mm) | 3V-24V | 15RPM-150RPM | 8kg.cm | 5mm diameter | Electric blinds, electric curtian, electric shutter,Robots, IoT,electric valve, |
| HT-WOG46(36x32mm) | 3V-24V | 1RPM-160RPM | 30kg.cm | 6mm diameter | Electric blinds, electric curtian, electris shutter, Robots, IoT, Electric valve |
| HT-WOG58A(58x40mm) | 6V-24V | 2RPM-160RPM | 80kg.cm | 8mm diameter | Electric lock, Electric valve, blinds, shutter, IoT, Robots |
| HT-WOG58B(58x40mm) | 6V-24V | 2RPM-160RPM | 80kg.cm | 8mm diameter | Electric lock, electric valve, blinds, Shutter, IoT, Robots |
| HT-WOG58C(58x40mm) | 6V-24V | 2RPM-160RPM | 80kg.cm | 8mm diameter | Electric lock, electric valves, blinds, shutter, IoT, Robots, |
We mainly develop and produce micro and small gearbox DC motors. What can we do for you :
1, Offer you proper DC Motor solutions to your design or products.
2, Provide you DC gearbox motors.
3, Customize the DC gear motors‘ performance to suit your need.
4, Develop new DC Gear motors for your product in case that our present models fail to meet your need.
5, Customize the output shafts, including D-shafts, keyway shafts, Round shafts, thread shafts, shafts with holes...
6, Cable and connectors to be welded to the motors‘ terminals.
Contact us free: [email protected]
Or pay a visit to our website: www.hotecmotor.com
